Note: Make sure the tray is pushed in all the way. Turn the tray upside down and tighten the screws to secure the drive in place.Ĥ Insert the loaded drive tray into the empty drive bay. Place the drive in the blue area (shown below) of the drive tray.
For 2.5″ drives: Remove the fastening panels from the sides of the drive tray and store them in a safe place. 
Then insert the fastening panels to secure the drive in place.
For 3.5″ drives: Remove the fastening panels from the sides of the drive tray. Install Drivesġ Press the right part of the drive tray to pop out the handle.Ģ Pull the drive tray handle in the direction as indicated below to remove the drive tray. Please back up any important data before installation. Warning: If you install a drive that contains data, the system will format the drive and erase all existing data. At least one 3.5″ or 2.5″ SATA drive (please visit for compatible drive models.). Dispose of used batteries appropriately.Ĭhapter 2 Hardware Setup Tools and Parts for Drive Installation Risk of explosion if battery is replaced with an incorrect type. To remove all electrical current from the device, ensure that all power cords are disconnected from the power source. Make sure that the supplied AC voltage is correct and stable. The power cord must plug in to the correct supply voltage. To prevent the unit from falling over, do not place on carts or any unstable surfaces. Place the product right side up at all times. Make sure the environment does not experience abrupt changes in temperature or humidity. ✟or more information about Synology Expansion Unit supported by your DiskStation, please visit 4 Safety Instructions Keep away from direct sunlight and away from chemicals. 14 Expansion Port Connect Synology Expansion Unit ¹ to the DiskStation here. 13 Console Port This port is used for manufacturing use only. Press and hold until you hear a beep sound, then press and hold again until you hear three beep sounds to return the DiskStation to “Not Installed” status so that DiskStation Manager (DSM) can be reinstalled. Press and hold until you hear a beep sound to restore the default IP address, DNS server, and password for the admin account.Ģ. 11 USB 3.0 Port Connect external drives or other USB devices to the DiskStation here. 10 PCI Express Expansion Slot Supports one PCIe x8 slot (x4 link) add-on card. If the fan malfunctions, the DiskStation will emit a beeping sound. 9 Fan Disposes of excess heat and cools the system. 8 Power Port Back Panel Connect the AC power cord here. 7 Drive Tray Lock Lock or unlock drive trays. 6 Drive Tray Install drives (hard disk drives or solid state drives) here. 
For more information, see “Appendix B: LED Indicator Table”. 5 Drive Status Indicator Displays the status of the installed drive.
4 LAN Indicator Displays the status of the network connection. To power off the DiskStation, press and hold until you hear a beep sound and the Power LED starts blinking. 2 Alert Indicator Displays warnings regarding fan or temperature.
Article Name Location Description 1 Status Indicator Front Panel Displays the status of the system. Screws for 2.5″ drives x 52 Drive tray key x 2
0 kommentar(er)
